Hi, does K803 support to output the information about interface and spoofing?
amor fati
18
Posts
10
Profile views
3
Likes
0
Followers
Hi, does K803 support to output the information about interface and spoofing?
I was checking my NMEA data and noticed that the number of satellites in view is always higher than the number of satellites actually being used for positioning. What is the difference between "vis...
That makes sense. However, if I send this command while I am actively connected to COM1, will my connection drop?
In a previous topic about high-frequency NMEA output, it was mentioned that we should use a baud rate of 115200 or higher for modules like the K803 and K902. How do I actually change the baud rate ...
That's very straightforward. Is there a maximum frequency limit I should be aware of for modules like the K803 or K827?
How can I change the output frequency of NMEA messages? I need the GPGGA message to output at 5Hz instead of the default 1Hz.
Awesome, thanks for the detailed step-by-step breakdown! This is very helpful for setting up the M20X in our testing vehicle. I will follow these instructions to get it connected.
Thanks! How do I set up and use the in-vehicle Ethernet port on the M20X?
Hi,what communication interfaces are available on the M20X Integrated Navigation Receiver?
Thanks! The data is logging now. However, I noticed the file size grows very quickly. Are there any tips to ensure I don't lose data during long observation sessions, and what should I do with the ...
Hi, I need to perform post-processed kinematic (PPK) analysis. How can I record the raw GNSS data (observation and ephemeris) from my K803 module to my computer?
Hi, could you tell me how can I check the module's SN number and firmware version?
Got it. If I turn off a specific signal or constellation, will the module remember this setting after I reboot it?
That's very clear, thank you. What if I want to disable an entire constellation, like GLONASS or Galileo, instead of just a single frequency?
Hi, can the module disable a specific GNSS frequency or signal?
Thanks for your explanation. I’m currently using the K803 module as both base and rover for RTK. Is it possible to check the satellite signal quality for both at the same time?
Thank you for your reply, it’s very helpful. Are there any related messages that I can use to extract these values?
Hello, I am a software engineer from USA, and I bought your product K803 module. May I know how to check the satellites and signal quality information of the GNSS module?
