How to enable and configure Ethernet in k902?

• r

  rumbetc1

  6/22/26, 2:44 AM

  We purchased K902 modules and developed a board with ethernet according to the datasheet. We used the command
  tst help
  ant - antenna status check
  config imu param
  config debug param
  config dr param
  config flash param
  help - print online help
  config imu param
  config net param
  rtc check
  config rtk param
  config com link cpu

  OK!
  Command accepted! Port: COM1

  tst net on

  OK!
  Command accepted! Port: COM1.
  eth init.
  Now the question is how to configure the K902 to operate on the network (IP address, port, DHCP). Because we see on the oscilloscope that the carrier on TX-, TX+, RX-, and RX+ is active, the circuit is working and only the module configuration commands are needed. #K902

  0 likes 0 likes Liked Like

  ---

  2
  Posts

  43
  Views

  Reply

  ---

• w

  will Admin

  6/23/26, 6:49 PM

  Hello Sir,

  Thank you for purchasing our product.

  We apologize for the inconvenience. Currently, the K902 only has the network interface hardware implemented, but command configuration and usage of the ethernet interface are not yet supported.

  Could you please tell us more about your application scenario? Are you trying to use the Ethernet interface for data communication, NTRIP, or another purpose?

  Also, would it be possible to use another communication interface (such as UART) for your application? We may be able to suggest an alternative solution based on your requirements.

  0 likes 0 likes Liked Like

  ---